BohH 90: Using the Wireless Microphone

  1. Obtain the keys.
  2. Unlock and open the equipment cabinet door.
  3. Turn on the classroom technology control system.
  4. Press the Audio button on the control panel.
  5. Turn on the wireless tuner.
  6. Press the Power button on the wireless unit.
  7. Adjust the sound.
  8. Turn off the power on the wireless microphone when finished.
  9. Turn off the power to the wireless tuner.
  10. Turn off the system.
  11. Close and lock the equipment cabinet door.

1. Obtain the keys.

The equipment cabinet key may be requested by departments or by faculty teaching in this room.

Classroom keys and building master keys do not open these locks. Departments with faculty or staff needing access to the AV /computer equipment may want to have a key in their department office available for checkout. Or faculty and staff who make frequent use of classroom equipment may want to request a key for their personal use. In either case, a key request card must be completed, signed by the Dean or Department Head, and delivered to Facilities Management Key Shop. "AV Cabinets" must be printed at the top of the card to specify that the requested key is for the equipment cabinet and not for the room itself. A separate key request card for the room must be completed to obtain a room key.

2. Unlock and open the cabinet doors.

A.V. equipment is located in the equipment cabinet/podium at the front of the room. This cabinet has two locks. Use the equipment cabinet key to unlock them.

One lock is located at the top, right side of the cabinet door.

Then open the doors.

3. Turn on the classroom technology control system.

This classroom is equipped with a control system panel that eliminates individual remote controls and power switches.

The control panel is located on top of the podium.

It is on the right side in the top right corner.

Press the ON button.

This button is the top, left one on the control panel.

The projector will begin warming up. After two to three minutes the projector will be ready for use.

4. Press the MIC button on the control panel.

This button is on the left of the control panel, second from the bottom.

5. Turn on the wireless tuner.

The wireless tuner is in the equipment cabinet. Turn on the tuner's power button, if it is not already on.

The power button is located on the left side of the unit.

After you turn on the tuner's power button an alert indicator and the LCD window will light up. The LCD display will appear after 1-2 seconds.

6. Press the Power button on the wireless unit.

Take it out of the cabinet and place it on you in the position you prefer for your presentation. If it is not already on, turn it on by pressing and holding the Power/Mute button for a second or two, until the red power indicator and LCD window have come on. If it doesn't illuminate replace its battery. Spare batteries are located in the cabinet. Do not press the Power/Mute button again or it will go into the mute mode.

The power button is located on the front of the unit.

7. Adjust the sound.

The control panel has several buttons to control and adjust sound.

You can mute, raise, or lower it.

Volume Buttons
There are two volume buttons. Press the second button from the top on the left side of the control panel to increase the volume. Press the button directly below that one to decrease the volume.
Mute Button
Press it once to cut the sound. Press it a second time to restore the sound. This button is the on the left side, on the bottom of the control panel.

8. Turn off the power on the wireless microphone when finished.

Press the power button.

The power button is located on the front of the unit.

Return it to the cabinet.

9. Turn off the power to the wireless tuner.

Press the power button.

The power button is located on the left side of the unit.

10. Turn off the system.

This button is the top, right one on the control panel.

The projector lamp will turn off. Approximately one second after that the, lamp will be cooled for about a minute. Then the system will be completely shut off.

11. Close and lock the equipment cabinet door.

Close and lock the doors using the equipment key.

One lock is located at the top, right side of the cabinet door.

Please double check to make sure that it is locked.

For immediate classroom technology help phone the AV desk at 726-6222.