MWAH 195: Using the Wireless Microphone.

1. Obtain the keys.

MWAH 195 equipment equipment cabinet key may be requested by departments or by faculty teaching in this room.

Classroom keys and building master keys do not open these locks. Departments with faculty or staff needing access to the AV /computer equipment may want to have a key in their department office available for checkout. Or faculty and staff who make frequent use of classroom equipment may want to request a key for their personal use. In either case, a key request card must be completed, signed by the Dean or Department Head, and delivered to Facilities Management Key Shop. "AV Cabinets" must be printed at the top of the card to specify that the requested key is for the equipment cabinet and not for the room itself. A separate key request card for the room must be completed to obtain a room key.

2. Unlock and open the equipment cabinet doors.

The projector controls and other equipment are located in the equipment cabinet in the middle of the second row of seats. Use the equipment key to unlock the cabinet.

Trip the latch on the top of the left hand door of this cabinet to allow it to open.

3. Turn on the audio amplifier.

The audio amplifier is located on the wall behind the overhead projector screen. Raise the screen.

Open the door to the amplifier controls.

The audio amplifier is normally left on, and a small red light on the front of the amplifier indicates when it is on. If the red light is not on, press the power button on the amplifier.

Check the audio amplifier volume levels. If the volume for the Wireless Mic is not correct adjust the dial on the amplifier labeled AUX1.

The dial on the amplifier labeled Master adjusts the overall volume level of all devices connected to the room audio system. Adjust it up or down as necessary, but be aware that this also adjusts the volume for any other devices that may be connected to the amplifier. It is best to adjust the volume using the AUX1 dial rather than Master.

Both the AUX1 and the Master amplifier controls may need to be set very high.

Set all level controls you will NOT be using to minimum. Then close the amplifier door.

4. Turn on the wireless tuner.

The wireless tuner is in the equipment cabinet. Turn on the tuner's power button.

After you turn on the tuner's power button an alert indicator and the LCD window will light up. The LCD display will appear after 1-2 seconds.

5. Test the microphone.

Take it out of the cabinet and place it on you in the position you prefer for your presentation.

Turn it on by pressing and holding the Power/Mute button for a second or two, until the red power indicator and LCD window have come on. Do not press the Power/Mute button again or it will go into the mute mode.

If the volume is not correct, check and adjust the dials on the amplifier as advised in step number 3 .

Set all level controls you will NOT be using to minimum so you do not experience audio feedback .

If you get stray signals from outside sources or have other problems with the unit , use the wired microphone and call Doug at 8151 for assistance.

6. Turn off the power off the wireless microphone when finished.

Press the power button.

7. Turn off the power to the wireless tuner.

Press the power button.

8. Replace the microphone when finished.

Place it in the cabinet.

9. Close and lock the equipment cabinet doors.

Close and lock the equipment cabinet doors using the equipment key.